How to use Polycell Plaster Repair Polyfilla Powder
Print
Step by step
- Difficulty leveltwo stars difficultylevel
- Ensure surface is dry and free from loose material. Rub down gloss surfaces.
- 1
-
- Touch in nails and screw heads with oil based paint and ensure all wiring in insulated.
- 2
-
- Add approximately 2-2.5 parts Polyfilla Plaster Repair Easy Mix Powder to 1 part water and mix to a smooth consistency.
- 3
-
- Wet the repair area thoroughly to promote good adhesion.
- 4
-
- Apply with a filling knife, trowel or float with upward sweeping strokes. Maintain a firm, even pressure.
- 5
-
- Do not fill more than 50mm in one application.
- 6
-
- Gently smooth off with a clean, wet float, cleaning and wetting as required
- 7
-
- Once the surface is firm but before it dries hard, re-wet and polish with a clean float for a smooth finish.
- 8
-
- Allow to dry for at least 24 hours (several days for deeper repairs).
- 9
-
- Store any unused powder in dry conditions.
- 10
-
- Wash hands after use and wash tools in warm water.
- 11
-
Questions?
Call us0333 222 7171
(on working days between 08:15 and 16:45)